1. Connect the two electrode wires to the channel outputs on the TENS PROTM device.

2. Attach the desired electrode pads to the ends of the electrode wires.

3. Remove the clear plastic film on each electrode pad and stick on the desired body area. Read the Warnings & Notices section of this guide before sticking on the electrode pads. Save the clear plastic film to stick back the electrode pads post use.

4. Press and hold the power button for 4 seconds to power up the device.

5. Select the desired massage mode by tapping it once on the touchpad. Tap the same massage mode Icon additional times to cycle through the sub-massage modes.

6. Once the massage mode is selected begin the session by tapping the iIntensity plus (+) symbol on the touchpad or the channel up button on the side of the device. You may adjust the intensity anytime during your massage session by tapping the (+) or (-) symbols or pressing the up or down buttons.

7. Once a massage session begins the timer countdown will start. Tap the timer to add 10
additional minutes to the countdown. The timer works with multiples of 10 minutes.

8. You may pause the session at any time by tapping the Play/Pause Icon.

9. You may lock the screen at any time by pressing the lock button. While in use, the screen will automatically lock after 30 seconds of inactivity.

10. Changing massage modes will reset the count- down timer and intensity parameters.

11. Power off the device by holding down the power,button for 4 seconds.